No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Costs of Default Routes Sent to Stub Areas

(Optional) Configuring Costs of Default Routes Sent to Stub Areas

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. Run area area-id

    The OSPF area view is displayed.

  4. Run stub [ no-summary ]

    The current area is configured as a stub area.

  5. Run default-cost cost

    The cost of the default route sent to the stub area is set.

    The parameter cost specifies the cost of the Type 3 default route sent to the stub area. The default cost is 1.

    This command applies only to the ABR that is connected to a stub area.

  6. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 276011

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next