No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Configuration Guide - IP Unicast Routing
CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing RIP Statistics

Clearing RIP Statistics


RIP information cannot be restored after it is cleared. Exercise caution when running the commands.

To clear RIP statistics, run the following reset commands in the user view.


  • Run the reset rip { process-id | all } imported-routes command to clear the routes imported from other routing protocols, including dynamic routes and direct routes, and import the routes to RIP again.
  • Run the reset rip { process-id | all } statistics command to clear the counters of a RIP process. This command is used to recount statistics during debugging.
Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 293834

Downloads: 168

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next