No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MD5 Authentication

Configuring MD5 Authentication


BGP uses TCP as the transmission protocol, and considers a packet valid as long as the source address, destination address, source port, destination port, and TCP sequence number of the packet are correct. However, most parameters in a packet may be easily obtained by attackers. To protect BGP from attacks, use MD5 authentication or keychain authentication between BGP peers to reduce the possibility of attacks. The MD5 algorithm is easy to configure and generates a single password that can only be manually changed.

If simple is selected during the configuration of the MD5 authentication password, the password is saved in the configuration file in plain text. This brings security risks. It is recommended that you select cipher to save the password in cipher text. MD5 authentication has potential security risks.


  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run peer { ipv4-address | group-name | ipv6-address } password { cipher cipher-password | simple simple-password }

    The MD5 authentication password is set.

    • To prevent the MD5 password set on BGP peers from being decrypted, update the MD5 password periodically.

    • BGP MD5 authentication and BGP keychain authentication are mutually exclusive, and only either of them can be configured for a BGP peer.

  4. Run commit

    The configuration is committed.

Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 274302

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next