No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for OSPF

Default Settings for OSPF

Table 5-21 describes the default settings for OSPF.

Table 5-21 Default settings for OSPF
Parameter Default Setting
OSPF Disabled
Interval for sending Hello packets By default, on P2P and broadcast interfaces, the interval for sending Hello packets is 10 seconds; on P2MP and NBMA interfaces, the interval is 30 seconds.
Dead interval of OSPF neighbor relationships By default, on P2P and broadcast interfaces, the dead interval after which an OSPF neighbor relationship expires is 40 seconds; on P2MP and NBMA interfaces, the interval is 120 seconds.
Period during which a device acts as a stub router 500 seconds
Bandwidth reference value used to calculate a link cost 100 Mbit/s
Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 272947

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next