No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
Configuration Guide - IP Unicast Routing
CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for Static Routes

Licensing Requirements and Limitations for Static Routes

Involved Network Elements

Other network elements are not required.

Licensing Requirements

Static routing is a basic feature of the CE12800 and CE12800E series switches and is not under license control.

Version Requirements

Table 2-2 Products and minimum version supporting static routes

Product

Minimum Version Required

CE12804/CE12808/CE12812

V100R001C00

CE12816

V100R003C00

CE12804S/CE12808S

V100R005C00

CE12804E/CE12808E/CE12816E

V200R002C50

Feature Limitations

If a switch has FD, FDA, FD1, FG, FG1, and SD cards installed, IP packet forwarding through the default route referenced in a VPN instance may fail because of insufficient routing and forwarding entries.

During an upgrade from V200R001C00SPC100 to a later version, if a static route's next hop is iterated to a remote VPN cross route and the next hop is a VXLAN tunnel, the static route is inactive in the source version but will become active in the target version. This modification will cause inconsistent traffic transmission paths before and after the upgrade. To prevent this issue, check whether a static route's next hop is iterated to a remote VPN cross route and the next hop is a VXLAN tunnel. If so, delete this static route.

Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 293832

Downloads: 168

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next