No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Failed to Receive RIP Update Packets from Neighbors

Failed to Receive RIP Update Packets from Neighbors

Fault Description

A device cannot receive RIP Update packets from neighbors when the link runs properly.


  1. Run the display current-configuration configuration rip command to check RIP configurations.

    • Check whether RIP has been enabled on the interface. Only the RIP-enabled interface can receive RIP packets.
    • Check whether the version number in the RIP packet sent by the peer interface matches the version number in the RIP packet received by the local interface. If not, the two interfaces cannot establish the RIP neighbor relationship.

  2. Run the display current-configuration interface interface-type interface-number command to view the interface configuration.

    • Check whether the undo rip input command has been executed on the interface. If the command has been executed, the interface does not receive RIP packets.
    • Check whether the authentication modes on the two ends of the link are the same. If the authentication modes are different, the interface cannot receive RIP packets from the peer.

Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 273034

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next