No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for OSPFv3

Default Settings for OSPFv3

Table 6-8 describes the default settings for OSPFv3.

Table 6-8 Default settings for OSPFv3
Parameter Default Setting
OSPFv3 Disabled
The interval of sending Hello packets For the interface of the broadcast type, the interval for sending Hello packets is 10 seconds.
The dead interval of the OSPFv3 neighbor The dead interval of OSPFv3 neighbor is 40 seconds for the interface of broadcast type.
The period during which a switch keeps acting as a stub router. 500 seconds
The bandwidth reference value used to calculate the link cost. 100 Mbit/s
Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 273041

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next