No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an OSPFv3 Dynamic Hostname

Configuring an OSPFv3 Dynamic Hostname

Compared with router IDs, Open Shortest Path First (OSPFv3) dynamic hostnames are easier to memorize. Therefore, using dynamic hostnames to identify routers can facilitate network management.

Pre-configuration Tasks

Before configuring a dynamic hostname, complete the following tasks:

  • Configure an IP address for each interface to ensure that neighboring routers can use the IP addresses to communicate with each other.
  • Configuring Basic OSPFv3 Functions

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospfv3 [ process-id ]

    The OSPFv3 process view is displayed.

  3. Run hostname [ hostname ]

    An OSPFv3 dynamic hostname is configured.

    NOTE:
    If you specify hostname in hostname command, hostname is advertised as the dynamic hostname. If no hostname is specified in hostname command, the hostname specified in the sysname command is advertised as the dynamic hostname.

  4. Run commit

    The configuration is committed.

Verifying the Configuration

Run the display ospfv3 hostname-table command to check OSPFv3 hostname information.

Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 273982

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next