No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adjusting the BGP Network Convergence Speed

Adjusting the BGP Network Convergence Speed

Pre-configuration Tasks

You can configure BGP timers, disable rapid EBGP connection reset, and configure BGP route dampening to speed up BGP network convergence and improve BGP security.

Before adjusting the BGP network convergence speed, complete the following task:

Configuration Procedure

You can perform the following configuration tasks as required. The following configuration tasks (excluding the task of Verifying the BGP Network Convergence Speed Adjustment Configuration) can be performed in any sequence.

Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 274521

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next