No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Resetting OSPFv3

Resetting OSPFv3


The OSPFv3 adjacency is removed when you reset the OSPFv3 connection. Exercise caution when running this command.

After modifying the OSPFv3 routing policy or protocol, reset the OSPFv3 connection to validate the modification. To reset OSPFv3 connections, run the following reset ospfv3 command in the user view.


  • To validate the new configuration, run the following commands:

    • reset ospfv3 { process-id | all }

    • reset ospfv3 { process-id | all } counters [ neighbor [ interface-type interface-number ] [ router-id ] ]

    • reset ospfv3 { process-id | all } counters maxage-lsa

    • reset ospfv3 process-id suppress-flapping peer [interface-type interface-number ] [ notify-peer ]

    • reset ospfv3 { process-id | all } peer [ interface-type interface-number ] router-id

Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 272210

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next