No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring OSPFv3 Stub Areas

Configuring OSPFv3 Stub Areas


Do as follows on each switch that runs OSPFv3 in the stub area:


  1. Run system-view

    The system view is displayed.

  2. Run ospfv3 [ process-id ]

    The OSPFv3 view is displayed.

  3. Run area area-id

    The OSPFv3 area view is displayed.

  4. Run stub [ no-summary ]

    The area is configured as a stub area.

  5. (Optional) Run default-cost cost

    The cost of the default route sent to the stub area is set.

    By default, the cost of the default route sent to the stub area is 1.

    This command is configured on the ABR of the stub area only to set the cost of the default route to be sent to the stub area. This command does not need to be configured on other switchs in the stub area.

    The parameter no-summary takes effect only when the stub command is configured on the ABR. If this parameter is configured, the ABR only sends the summary-LSA of a default route to the stub area without originating other summary-LSAs. The stub area without AS-external-LSAs or Summary-LSAs is called a totally stub area.

  6. Run commit

    The configuration is committed.

Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 271765

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next