No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Stub Router

Configuring a Stub Router


A stub router is used to control traffic and instructs other OSPF routers not to use it to forward data. Other OSPF routers can have a route to the stub router.

In the Router LSAs generated by a stub router, the costs of all links are set to the maximum value (65535).


  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. Run stub-router [ on-startup [ interval ] ]

    A stub router is configured.

    The parameter on-startup [ interval ] specifies the interval during which the switch acts as a stub router. By default, the interval is 500 seconds.


    A stub router configured using this command bears no similarity to a switch in a stub area.

  4. Run commit

    The configuration is committed.

Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 274208

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next