No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Configuration Guide - IP Unicast Routing
CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Association between OSPFv3 and BGP

Association between OSPFv3 and BGP

When a new router is deployed in the network or a router is restarted, the network traffic may be lost during BGP convergence. This is because IGP convergence is quicker than BGP convergence. This problem can be solved through the association between OSPFv3 and BGP.

If a router on a BGP network recovers from a fault, BGP convergence is performed again and certain packets may be lost during the convergence.

As shown in Figure 6-5, traffic from RouteA to RouterD passes through RouterC, and traverses a BGP network.

Figure 6-5 Traffic traversing a BGP network

If a fault occurs on RouterC, traffic is redirected to RouterB after rerouting. Packets are lost when RouterC is restored to the normal status.

Because OSPFv3 convergence is quicker than BGP convergence, OSPFv3 convergence is complete when RouterC recovers. The next hop of the route from RouterA to RouterD is RouterC, which, however, does not know the route to RouterD since BGP convergence on RouterC is not complete.

When the packets destined for RouterD are transmitted from RouterA to RouterC, they are discarded by RouterC because RouterC has no route to RouterD, as shown in Figure 6-6.

Figure 6-6 Packet loss during the restart of the device not enabled with association between OSPFv3 and BGP

Process of Association between OSPFv3 and BGP

When a router enabled with association between OSPFv3 and BGP restarts, the router advertises a message in the local OSPFv3 area to instruct other routers not to use it as a transit router.

At the same time, the router sets the largest weight value of 65535 in its LSAs to ensure that it is not used by other routers as the transit router. The BGP route, however, can still reach the router.

Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 294098

Downloads: 168

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next