No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Configuration Guide - QoS
CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of QoS functions, including MQC, priority mapping, traffic policing, traffic shaping, interface-based rate limiting, congestion avoidance, congestion management, packet filtering, redirection, traffic statistics, and ACL-based simplified traffic policy.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Priority Mapping

Configuring Priority Mapping

After you configure priority mapping, the device maps packet priorities or the default interface priority to PHBs and colors to provide differentiated services for packets.

Configuration Roadmap

The configuration roadmap is as follows:

  1. Specify the packet priority trusted by an interface so that priority mapping is performed according to the trusted priority.
  2. Configure a DiffServ domain to determine the mappings between packet priorities and internal priorities (CoS values). This allows the device to provide differentiated services according to internal priorities.
  3. Apply the DiffServ domain to an object so that the mappings take effect. The device can then re-mark priorities of packets according to the mappings.
  4. (Optional) Configure mappings from internal priorities to queue indexes to schedule packets with different internal priorities in different queues. This step is optional because the device provides default mappings from internal priorities to queue indexes.

Pre-configuration Tasks

Before configuring priority mapping, complete the following tasks:

  • Set physical parameters for relevant interfaces.
  • Set the link-layer attributes for relevant interfaces.
Updated: 2019-03-21

Document ID: EDOC1000166605

Views: 65583

Downloads: 84

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next