No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Reliability

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, EFM Configuration, and CFM Configuration.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of BFD Configuration Tasks

Summary of BFD Configuration Tasks

The device supports the following BFD features: BFD session setup, BFD detection mode, single-hop and multi-hop BFD, static BFD with automatically negotiated discriminators, VPN route detection, BFD to detect an Eth-Trunk in a VLAN, BFD to detect an Eth-Trunk member link, BFD association, and dynamic change of BFD parameters.

Table 2-5 describes the BFD configuration tasks.

Table 2-5 BFD configuration tasks




Configure single-hop BFD.

Single-hop BFD quickly detects faults on the directly connected link.

Configuring Single-Hop BFD

Configure multi-hop BFD.

Multi-hop BFD quickly detects faults on the indirectly connected link.

Configuring Multi-Hop BFD

Configure static BFD with automatically negotiated discriminators.

To enable a local device to communicate with a remote device that uses dynamic BFD and detect static routes, create a BFD session with automatically negotiated discriminators. This function is mainly used in scenarios where static routes are used to implement Layer 3 connectivity.

Configuring Static BFD with Automatically Negotiated Discriminators

Configure BFD to detect VPN routes.

BFD quickly detects faults on the VPN routes.

Configuring BFD to Detect VPN Routes

Configure BFD to detect an Eth-Trunk in a VLAN.

BFD for Perlink quickly detects and monitors an Eth-Trunk in a VLAN.

Configuring BFD to Detect an Eth-Trunk in a VLAN

Configure BFD to detect an Eth-Trunk member link.

BFD for Link-bundle quickly detects and monitors Layer 3 Eth-Trunk member links.

Configuring BFD to Detect a Layer 3 Eth-Trunk Member Link

Configure BFD association.

Association between BFD and other protocols improves upper-layer application performance and quickly detects faults on links.

Configuring BFD Association

Adjust BFD parameters.

You can adjust BFD parameters so that the BFD session can quickly detect faults on links.

Adjusting BFD Parameters

Updated: 2019-03-21

Document ID: EDOC1000166606

Views: 157481

Downloads: 91

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next