No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, EFM Configuration, and CFM Configuration.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
BFD for OSPF

BFD for OSPF

A link failure or topology change may lead to route recalculation. Therefore, the convergence time of routing protocols must be as short as possible to ensure good network performance. A possible solution is to quickly detect link faults and immediately notify routing protocols of the faults.

BFD for OSPF associates a BFD session with OSPF. The BFD session quickly detects a link fault and notifies OSPF of the fault. OSPF quickly responds to the network topology change. Table 2-1 lists OSPF convergence time.

Table 2-1 OSPF convergence time

BFD Session

Link Fault Detection Mechanism

Convergence Time

Not bound

Timeout of the OSPF Hello keepalive timer

Measured in seconds

Bound

BFD session in Down state

Measured in milliseconds

Networking

Figure 2-6 BFD for OSPF

In Figure 2-6, SwitchA establishes OSPF neighbor relationships with SwitchC and SwitchD. The outbound interface in the route from SwitchA to SwitchB is Interface 1. Packets from SwitchA are sent to SwitchB through SwitchC. When the OSPF neighbor relationship is in Full state, the system instructs BFD to create a BFD session.

If a fault occurs on the link between SwitchA and SwitchC, the BFD session detects the fault and notifies SwitchA. SwitchA processes the neighbor Down event and recalculates the route. Interface 2 then becomes the new outbound interface in the route. Packets from SwitchA are sent to SwitchB through SwitchD.

Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166606

Views: 90302

Downloads: 84

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next