No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Virtualization

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of virtualization, including stack and VS.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Splitting a Stack

Splitting a Stack

Context

If a stack is not required, split the stack to restore the member switches to standalone switches.

To split a stack, disable the stacking function on member switches, and then remove stack cables between the member switches. After you disable the stacking function, the member switches restart without a configuration file.

When you disable the stacking function, the member switches automatically back up the configuration file to the flash:/ directory. The backup file name is in format Configuration file name + yyyymmddhhmmss. For example, if the original configuration file is vrpcfg.cfg and you disable the stacking function at 11:17:16 on 2012-12-11, the backup configuration file is named vrpcfg20121211111716.cfg.

NOTE:

When splitting a stack, you are advised to connect all member switches through their console ports. If you connect member switches through their management interfaces, you cannot log in to the switches through their management interfaces because they run without a configuration file after the stack is split.

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the stack command to enter the stack management view.
  3. Run the undo stack enable member { member-id | all } command to disable the stacking function.

    After you disable the stacking function, the member switches restart without a configuration file.

  4. Remove stack cables.
Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166610

Views: 44256

Downloads: 131

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next