No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Virtualization

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of virtualization, including stack and VS.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Restarting a VS

Restarting a VS

Context

The physical system (PS) administrator and VS administrator can restart a VS. The PS administrator can run commands in the Admin-VS to restart a VS; the VS administrator can restart a local VS after logging in to the VS.
NOTE:
  • Only a non-admin-VS can be restarted.

  • It is not recommended to restart multiple VSs at the same time. Otherwise, the VS configurations may be incorrect.

  • Before restarting a VS, save configurations on the VS; otherwise, the configurations may get lost.

  • During the VS restart, all interfaces on the VS are shut down, services are interrupted, and users on the VS are disconnected.

  • If the active/standby switchover is performed during the VS restart, all interfaces are in Down state after the VS restarts. You can restart the VS to solve the problem.

  • During the restart of a VS, service traffic will be interrupted for a certain period after ports of the VS become Up again. You are advised to shut down the ports of the VS before restarting the VS and enable the ports 1 minute after the VS is restarted.

Procedure

  • Restart the VS as the PS administrator.
    1. Run the reset virtual-system vs-name command in the user view of the PS to restart a VS.
  • Restart the VS as the VS administrator.
    1. Run the reset command in the user view of a VS to restart the VS.
Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166610

Views: 43993

Downloads: 131

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next