No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Device MAC Address

Configuring the Device MAC Address

Context

Billions of devices exist on global networks, and each device has a MAC address. Theoretically, each device has a unique MAC address. However, MAC address conflicts may occur because of incorrect MAC address configuration. In addition, you may need to use a specified MAC address for a device. In these situations, you need to change the device's current MAC address.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run set system mac-address mac-address mac-num mac-num

    The device MAC address is set.

    By default, the device is assigned a default MAC address upon delivery.

    NOTE:
    • The configured MAC address takes effect after the device restarts.

    • The device's MAC address cannot be all 0s, all 1s, a multicast MAC address, or an invalid unicast MAC address.

    • If the number of MAC addresses is 16, the last hexadecimal digit of these MAC addresses must be 0.

    • The device's MAC address cannot be a MAC address in the MAC address table.
    • The device's MAC address cannot be 0000-5e00-01XX or 0000-5e00-02XX.
    • The set system mac-address mac-num command is mutually exclusive with the set system mac-address slot slot-id command that sets the stack system MAC address. You cannot execute both commands on the same device.

  3. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166632

Views: 81770

Downloads: 312

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next