No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Debugging Message Output

Configuring Debugging Message Output

Pre-configuration Tasks

Before enabling debugging message output, start the Switch.

Debugging occupies CPU resources on the device, affecting system running. After debugging, run the undo debugging all command to disable it immediately.

Configuration Procedure

Table 3-11 lists the configuration process for enabling debugging message output.
Table 3-11 Configuration process for enabling debugging message output

No.

Configuration Task

Description

Remarks

1

Enabling the Information Center

You can configure the information center only after the information center is enabled.

By default, the information center is enabled.

Steps 2 and 3 are optional and can be performed in any sequence.

2

(Optional) Naming an Information Channel

You can rename channels, which facilitates memorization and usage.

3

(Optional) Setting the Timestamp Format of Debugging Messages

To adjust the time format and time precision for information output, configure the timestamp.

4

Configuring the Device to Output Debugging Messages to the Console

After debugging messages are output to the console, you can view debugging messages on the console (host from which you can log in to the Switch through the console interface) to monitor device running.

Steps 4 to 5 can be performed in any sequence. You can configure the device to output debugging messages to one or more destinations according to your needs.

5

Configuring the Device to Output Debugging Messages to the Terminal

After debugging messages are output to a user terminal, you can view debugging messages on the user terminal (host from which you log in to the Switch through STelnet) to monitor device running.

Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166632

Views: 81353

Downloads: 312

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next