No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Device to Output Logs to the Console

Configuring the Device to Output Logs to the Console

Context

After logs are output to the console, you can view logs on the console (host from which you can log in to the device through the console interface) to monitor the device status.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run info-center console channel { channel-number | channel-name }

    A channel through which logs are output to the console is specified.

    By default, the device uses channel 0 to output logs to the console.

  3. Run info-center source { module-name | default } channel { channel-number | channel-name } log { state { off | on } | level severity } *

    A rule for outputting logs to a channel is set.

    By default, channel 0 is enabled to output logs and the lowest log severity is warning.

  4. Run commit

    The configuration is committed.

  5. Run quit

    Return to the user view.

  6. Run terminal monitor

    Display of logs, traps, and debugging message output is enabled on the user terminal.

    By default, console display is enabled and terminal display is disabled.

  7. Run terminal logging

    Log display is enabled on the user terminal.

    By default, log display is enabled on the user terminal.

Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166632

Views: 80712

Downloads: 308

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next