No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50 Configuration Guide - Virtualization

This document describes the configurations of virtualization, including stack and SVF.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Stack Domain ID and a Stack Member ID

Configuring a Stack Domain ID and a Stack Member ID

Context

When setting up an SVF system, a parent switch must have a stack domain ID configured and its stack member ID must be less than or equal to 4. Otherwise, an SVF system cannot be set up.

To check whether the stack domain ID and stack member ID of a parent switch meet the preceding requirements, run the display stack configuration [ member member-id | all ] command. If so, skip this section. If not, change the SVF configuration to meet the preceding requirements.

Procedure

  • Configure a stack domain ID.
    1. Run the system-view command to enter the system view.
    2. Run the stack command to enter the stack management view.
    3. Run the stack member { member-id | all } domain domain-id command to set the stack domain ID.

      By default, a switch has no stack domain ID.

    4. Run the commit command to commit the configuration.
    5. Run the return command to return to the user view.
    6. Run the save command to save the device configuration to make the configured stack domain ID take effect.

      If the switch has no stack domain ID, the configured stack domain ID takes effect after the device configuration is saved. If you change the existing stack domain ID, the new ID takes effect after the switch restarts.

  • Configure a stack member ID.
    1. Run the system-view command to enter the system view.
    2. Run the stack command to enter the stack management view.
    3. Run the stack member member-id renumber new-member-id [ inherit-config ] command to set the stack member ID to 4 or less.

      By default, the stack member ID of a switch is 1.

    4. Run the commit command to commit the configuration.
    5. Run the return command to return to the user view.
    6. Run the reboot command to restart the device to make the configured stack member ID take effect.

      After changing the stack member ID, restart the switch for the configuration to take effect.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1000166645

Views: 52171

Downloads: 336

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next