No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50 Configuration Guide - Virtualization

This document describes the configurations of virtualization, including stack and SVF.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Up a Stack by Configuring Software and Then Connecting Stack Cables

Setting Up a Stack by Configuring Software and Then Connecting Stack Cables

You can complete software configuration before connecting stack cables if you are at the device deployment site. This stack setup procedure is simple, as shown in Figure 1-28.

If you want to connect stack cables before remotely completing software configuration, see Setting Up a Stack by Connecting Stack Cables and Then Configuring Software.
Figure 1-28 Setting up a stack by configuring software and then connecting stack cables
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1000166645

Views: 46396

Downloads: 312

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next