No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50 Configuration Guide - Virtualization

This document describes the configurations of virtualization, including stack and SVF.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Splitting a Stack

Splitting a Stack

Context

You are advised to perform the following operations to split a stack:
  1. Back up the stack configuration file in case the stack will be used again.

  2. Clear the stack configuration and restart member switches. After the switches restart, they run as standalone switches without a configuration file.

  3. Remove stack cables.

NOTE:

When splitting a stack, you are advised to connect all member switches through their console ports. If you connect member switches through their management interfaces, you cannot log in to the switches through their management interfaces because they run without a configuration file after the stack configuration is cleared.

If you delete the stack configuration step by step instead of clearing the stack configuration to split a stack, after the stack is split, you need to change IP addresses of some member switches to prevent an IP address conflict.

Procedure

  1. Run the save command to save the configuration.
  2. Run the copy source-filename destination-filename all command to back up the configuration file to all the member switches.
  3. Run the reset saved-configuration command to clear the stack configuration.
  4. Run the reboot command to restart the stack.

    After the stack is restarted, each member switch runs as a standalone switch without a configuration file.

    NOTE:

    When restarting a stack, do not save the configuration.

  5. Remove stack cables between the member switches.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1000166645

Views: 55669

Downloads: 344

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next