No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CloudEngine 8800, 7800, 6800, and 5800 V200R002C50 Configuration Guide - Virtualization

This document describes the configurations of virtualization, including stack and SVF.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Stack Login

Stack Login

After a stack is set up, the member switches are virtualized into one device on the network, and all resources on the member switches are managed by the master switch. You can log in to the stack from any member switch to manage and maintain the entire stack. When you log in to a stack, you actually log in to the master switch, regardless of what login method you use and which member switch you have logged in to.

You can log in to a stack using the following methods:
  • Local login: Log in through the console interface of any member switch.

  • Remote login: Log in through the management interface or another Layer 3 interface of any member switch, using remote login protocols such as Telnet and STelnet.

    • After a stack is set up, the configuration file of the master switch takes effect in the stack. Therefore, you must specify the IP address of the master switch when logging in to the stack remotely.

    • After a stack is set up, the management interfaces of all stack members share the same IP address (IP address of the management interface on the master switch). When the management interfaces of multiple stack members are connected to the management network, only the management interface of one stack member is working. By default, the management interface on the master switch is working. If this interface becomes faulty or unavailable, the management interface on another stack member is working.

Updated: 2019-04-20

Document ID: EDOC1000166645

Views: 55344

Downloads: 344

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next