No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CloudEngine 8800, 7800, 6800, and 5800 V200R002C50 Configuration Guide - Virtualization

This document describes the configurations of virtualization, including stack and SVF.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Performing a Master/Standby Switchover in a Stack

Performing a Master/Standby Switchover in a Stack


You can manually trigger a master/standby switchover in a stack if the current roles of member switches do not meet your requirement. For example, you can perform a master/standby switchover to change the roles after a restart or restore the original roles after an upgrade.


  1. (Optional) Run the display switchover state command to check whether the stack meets switchover requirements.

    You can perform a switchover only if the Switchover State field is Ready.

  2. Run the system-view command to enter the system view.
  3. Run the slave switchover enable command to enable the master/standby switchover function.

    By default, the master/standby switchover function is enabled.

  4. Run the slave switchover command to perform a master/standby switchover.
Updated: 2019-04-20

Document ID: EDOC1000166645

Views: 55070

Downloads: 344

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next