Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling SR-IOV
- When the following screen is displayed, press F11 to enter the Boot Manager screen.Figure 4-65 Pressing F11 to go to Boot Manager
Press ESC to exit. Select Device Manager and press Enter.
Figure 4-66 Selecting Device Manager - On the Device Manager screen, select Network Device List and press Enter.Figure 4-67 Selecting Network Device List
- Select a port and press Enter. On the displayed screen, press Enter again to confirm the selection.Figure 4-68 Selecting a portFigure 4-69 Confirming the selection
- On the Main Configuration Page screen, select Multi-Function Mode, press Enter, and select SR-IOV or NPAR+SR-IOV to enable NPAR.Figure 4-70 Enabling SR-IOV
Multi-Function Mode can be used to configure both NPAR and SR-IOV. If it is set to SR-IOV, SR-IOV is enabled in non-NPAR mode, which is the Single Function (SF) mode. If it is set to NPAR+SR-IOV, SR-IOV is enabled in NPAR mode.
- Press Esc repeatedly until the following screen is displayed. Press Y to save the configurations.Figure 4-71 Saving the configurations
- Press Enter to restart.Figure 4-72 Prompt for restart
