Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring SAN Boot
You can configure SAN Boot in the QLogic BIOS.
To configure SAN Boot, perform the following steps:
- Start the MZ522, and press Ctrl+S to enter the QLogic BIOS when the message shown in Figure 4-29 is displayed.
- Select a port.Figure 4-30 Selecting a port for SAN Boot
- Choose MBA Configuration and set Boot Protocol to FCoE.Figure 4-31 Setting the boot protocol to FCoE
- Choose FCoE Boot Configuration > General Parameters. On the displayed screen shown in Figure 3 Enabling FCoE SAN Boot, set Boot to FCoE Target to Enabled.Figure 4-32 Enabling FCoE SAN Boot
- Choose FCoE Boot Configuration > Target Information.
- The boot device setting screen is displayed.Figure 4-33 Boot device setting screen
Set Connect to Enabled, enter the WWPN of the remote storage port, and set Boot LUN.
Figure 4-34 Setting the boot device WWPN and LUN - Press Esc. On the displayed Exit Configuration screen, select Exit and Save Configurations and press Enter.Figure 4-35 Saving SAN Boot configurations
- Manually restart the server for the configurations to take effect.Figure 4-36 Prompt for restart
