No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
CX920 Switch Module V100R001 User Guide 09
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Switching Service Data

Configuring Switching Service Data

This topic describes how to configurethe CX920 10GE switching plane and 40GE switching plane feature data after the CX920 meets the basic configuration conditions.

Procedure

  1. Configure the features of the 10GE switching plane and 40GE switching plane in the CX920.

    The following describes the feature configurations of the 10GE switching plane and 40GE switching plane. For details, see CX920 Switch Module Configuration Guide.

    • Interface Management
      • Basic Configuration for Interfaces
      • Ethernet Interfaces Configuration
      • Logical Interface Configuration
    • Ethernet Switching
      • MAC Address Table Configuration
      • Link Aggregation Configuration
      • VLAN Configuration
      • QinQ Configuration
      • VLAN Mapping Configuration
      • STP/RSTP Configuration
      • MSTP Configuration
      • Loopback Detection Configuration
    • IP Service
      • IP Address Configuration
      • ARP Configuration
      • DHCP Configuration
      • DNS Configuration
      • UDP Helper Configuration
      • IP Performance Configuration
    • IP Routing
      • Static Route Configuration
      • RIP Configuration
      • OSPF Configuration
      • OSPFv3 Configuration
      • IPv4 IS-IS Configuration
      • BGP Configuration
      • Routing Policy Configuration
    • IP Multicast
      • IGMP Configuration
      • PIM (IPv4) Configuration
      • MSDP Configuration
      • Multicast Route Management (IPv4) Configuration
      • IGMP Snooping Configuration
      • Static Multicast MAC Address Configuration
      • Multicast Network Management
    • QoS
      • Priority Mapping Configuration
      • Traffic Policing and Traffic Shaping Configurations
      • Congestion Avoidance and Congestion Management Configuration
    • Security
      • AAA Configuration
      • ACL Configuration
      • Local Attack Defense Configuration
      • MFF Configuration
      • Traffic Suppression and Storm Control Configuration
      • ARP Security Configuration
      • DHCP Snooping Configuration
      • IPSG Configuration
      • URPF Configuration
      • Keychain Configuration
    • Reliability
      • BFD Configuration
      • VRRP Configuration
      • DLDP Configuration
    • Device Management
      • Displaying the Device Status
      • Hardware Management
      • Information Center Configuration
      • Fault Management Configuration
      • Energy-Saving Management
    • Network Management
      • SNMP Configuration
      • RMON Configuration
      • NETCONF Configuration
      • LLDP Configuration
      • NQA Configuration
      • Packet Capture Configuration
    • Virtual Perception

Translation
Download
Updated: 2019-12-04

Document ID: EDOC1000170901

Views: 25132

Downloads: 184

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next