No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Defining the Current Area as a Stub Area

Defining the Current Area as a Stub Area


  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. Run area area-id

    The OSPF area view is displayed.

  4. Run stub [ no-summary | default-route-advertise backbone-peer-ignore ] *

    The specified area is configured as a stub area.

    • The parameter no-summary is used to forbid the ABR to send Type 3 LSAs to the stub area.
    • The parameter default-route-advertise is used to enable the ABR to generate default Type 3 LSAs and advertise them to the stub area.

    • The parameter backbone-peer-ignore is used to prevent the ABR from checking the neighbor status when the ABR generates default Type 3 LSAs and advertises them to the stub area. Specifically, the ABR generates default Type 3 LSAs and advertises them to the stub area as long as an interface that is Up exist in the backbone area.

    • Stub attributes must be configured on all routers in a stub area using the stub command.
    • Configuring or deleting stub attributes will update routing information in the area. Stub attributes can be deleted or reconfigured only after the routing update is complete.

Updated: 2019-12-27

Document ID: EDOC1000174069

Views: 187692

Downloads: 316

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next