No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring SPR

Configuring SPR

Based on the link quality requirement, you can configure SPR to dynamically switch service transmission links.

Pre-configuration Tasks

Before configuring SPR, complete the following tasks:

  • Configuring link layer parameters and IP addresses for interfaces so that the link layer protocol of the interfaces is Up and the route is reachable.

  • Configuring ACLs to classify service flows.

  • Configuring NQA test instances to detect link quality.

    NOTE:
    You need to configure the NQA client on the service end and the NQA server on the peer end.
Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 130511

Downloads: 274

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next