No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Basic OSPFv3 Function Configuration

Verifying the Basic OSPFv3 Function Configuration

Prerequisites

The configurations for basic OSPFv3 functions are complete.

Procedure

  • Run the display ospfv3 [ process-id ] command to check the summary information about the OSPFv3 process.
  • Run the display ospfv3 [ process-id ] interface [ area area-id ] [ interface-type interface-number ] command to check the OSPFv3 interface information.
  • Run the commands as follow to check the LSDB information about OSPFv3:

    • display ospfv3 [ process-id ] lsdb [ area area-id ] [ originate-router advertising-router-id | self-originate ] [ { router | network | inter-router [ asbr-router asbr-router-id ] | { inter-prefix | nssa } [ ipv6-address prefix-length ] | link | intra-prefix | grace } [ link-state-id ] ]

    • display ospfv3 [ process-id ] lsdb [ originate-router advertising-router-id | self-originate ] external [ ipv6-address prefix-length ] [ link-state-id ]

  • Run the display ospfv3 [ process-id ] [ area area-id ] peer [ interface-type interface-number ] [ verbose ] command or display ospfv3 [ process-id ] [ area area-id ] peer neighbor-id [ verbose ] command to check the information about the OSPFv3 neighbor.
  • Run the display ospfv3 [ process-id ] routing [ abr-routes | asbr-routes | statistics [ uninstalled ] | ipv6-address prefix-length | intra-routes | inter-routes | ase-routes | nssa-routes ] command as follow to check the OSPFv3 routing table:
  • Run the display ospfv3 [ process-id ] path command to check the paths to a destination address.
  • Run the display default-parameter ospfv3 command to check the default OSPFv3 configuration.
Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 111624

Downloads: 250

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next