No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Controlling IPv6 IS-IS Route Exchange

Controlling IPv6 IS-IS Route Exchange

If other routing protocols are configured on an IS-IS network, you need to configure IS-IS to interact with these protocols to ensure successful communication between them.

Pre-configuration Tasks

Before controlling IS-IS route exchange, complete the following task:

Configuration Procedure

You can perform the following configuration tasks (excluding the task of Verifying the IPv6 IS-IS Route Exchange Control Configuration) in any sequence as required.

Translation
Download
Updated: 2019-12-27

Document ID: EDOC1000174069

Views: 199922

Downloads: 356

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next