No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Extended Community Filter

Configuring an Extended Community Filter

Context

You can use an extended community filter when using the route target (RT) attribute to filter routes in a VPN scenario.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ip extcommunity-filter { basic-extcomm-filter-num | basic basic-extcomm-filter-name } { deny | permit } { rt { as-number:nn | 4as-number:nn | ipv4-address:nn } } &<1-16> or ip extcommunity-filter { advanced-extcomm-filter-num | advanced advanced-extcomm-filter-name } { deny | permit } regular-expression

    An extended community filter is configured.

Verifying the Configuration

Run the display ip extcommunity-filter [ basic-extcomm-filter-num | advanced-extcomm-filter-num | extcomm-filter-name ] command to check information about a configured extended community filter.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 111602

Downloads: 250

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next