No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Enabling the Mesh-Group Function

(Optional) Enabling the Mesh-Group Function

Context

When concurrent links exist between two routers, you can enable the mesh-group function to reduce the load on the links.

The neighboring router ID identifies each mesh group. Several concurrent links are added to a mesh group. Flooding is implemented once in the group. You can add interfaces that meet the following conditions to the same mesh group.

  • The interfaces belong to the same area and OSPF process.
  • The interfaces begin to exchange DD packets.
  • The interfaces are connected to the same neighboring router.

Perform the following steps on the router running OSPF.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. Run mesh-group enable

    The mesh-group function is enabled.

    By default, the mesh-group function is disabled.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 113886

Downloads: 254

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next