No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Cost of the OSPFv3 Interface

Setting the Cost of the OSPFv3 Interface

Context

You can control route calculation by setting the link cost of OSPFv3 on different interfaces.

Do as follows on the router that runs OSPFv3.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ospfv3 cost cost [ instance instance-id ]

    The cost is set on the OSPFv3 interface.

    By default, the link cost on an OSPFv3 interface is 1.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 113250

Downloads: 254

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next