No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the OSPF Packet Retransmission Limit

Setting the OSPF Packet Retransmission Limit


After an OSPF router sends one of the following packets, if it does not receive the LSAck packet within a specified time, it retransmits the packet. After the number of packet retransmissions reaches the set limit, the OSPF router tears down the adjacency relationship with its neighbor.
  • DD packets
  • LSU packets
  • LSR packets


  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF view is displayed.

  3. Run retransmission-limit [ max-number ]

    The OSPF packet retransmission limit is set.

    By default, the OSPF packet retransmission limit is not set. The default maximum number of packet retransmissions is 30.

Updated: 2019-12-27

Document ID: EDOC1000174069

Views: 199759

Downloads: 356

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next