No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic OSPF Functions

Configuring Basic OSPF Functions

Before building OSPF networks, you need to configure basic OSPF functions.

Applicable Environment

When OSPF is configured on multiple routers in the same area, most configuration data, such as the timer, filter, and aggregation, must be planned uniformly in the area. Incorrect configurations may cause neighboring routers to fail to send messages to each other or even causing routing information congestion and self-loops.

The OSPF-relevant commands that are configured in the interface view take effect regardless of whether OSPF is enabled. After OSPF is disabled, the OSPF-relevant commands also exist on interfaces.

Pre-configuration Tasks

Before configuring basic OSPF functions, complete the following task:

  • Configuring IP addresses for interfaces to ensure that neighboring nodes are reachable at the network layer

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 113624

Downloads: 254

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next