No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the Default Preference for IPv4 Static Routes

(Optional) Setting the Default Preference for IPv4 Static Routes

Context

The default preference of IPv4 static routes affects route selection. When an IPv4 static route is configured, the default preference is used if no preference is specified for the static route.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ip route-static default-preference preference

    The default preference of static routes is set.

    By default, the preference of static routes is 60.

    NOTE:

    After the default preference is reconfigured, the new default preference is valid only for new IPv4 static routes.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 132945

Downloads: 274

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next