No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Interval for Updating LSAs

Setting the Interval for Updating LSAs

Context

In OSPF, the interval for updating LSAs is defined as 5s. This aims to prevent network connections or frequent route flapping from consuming excessive network bandwidth or device resources.

On a stable network where routes need to be fast converged, you can cancel the interval for updating LSAs by setting the interval to 0 seconds. In this manner, changes to the topology or the routes can be immediately advertised on the network through LSAs, thereby speeding up route convergence on the network.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. Run lsa-originate-interval { 0 | { intelligent-timer max-interval start-interval hold-interval | other-type interval } * }

    The interval for updating LSAs is set.

    • The parameter intelligent-timer indicates that the interval for updating router LSAs and network LSAs is set through an intelligent timer.
    • The parameter max-interval specifies the maximum interval for updating LSAs, in milliseconds.
    • The parameter start-interval specifies the initial interval for updating LSAs, in milliseconds.
    • The parameter hold-interval specifies the hold interval for updating LSAs, in milliseconds.
    • The parameter other-type interval indicates that the interval for updating LSAs excluding Router LSAs and Network LSAs is set.
    By default, an intelligent timer is enabled. After an intelligent timer is enabled, the default maximum interval for updating LSAs is 5000 ms, the default initial interval is 500 ms, and the default hold interval is 1000 ms. Details about the interval for updating LSAs are as follows:
    1. The initial interval for updating LSAs is specified by start-interval.
    2. The interval for updating LSAs for the nth (n ≥ 2) time is equal to hold-interval x 2(n-2).
    3. When the interval specified by hold-interval x 2(n-2) reaches the maximum interval specified by max-interval, OSPF updates LSAs at the maximum interval for three consecutive times. Then, OSPF goes back to step 3.a and updates LSAs at the initial interval specified by start-interval.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 144137

Downloads: 280

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next