Rate and give feedback
:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Stub Routers
Context
A stub router is used to control traffic. It notifies OSPFv3 routers not to forward data by the stub router, but they can have a route to the stub router.
Do as follows on the router that runs OSPFv3:
Procedure
- Run system-view
The system view is displayed.
- Run ospfv3 [ process-id ]
The OSPFv3 process view is displayed.
- Run stub-router [ on-startup [ interval ] ]
The stub router is configured.
![]()
NOTE: There is no correlation between the stub router configured through this command and the router in the stub area.
Previous
