No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic RIPng Functions

Configuring Basic RIPng Functions

Basic RIPng functions include creating RIPng processes and enabling RIPng on interfaces. The basic RIPng functions must be configured before you use RIPng features.

Pre-configuration Tasks

Before configuring basic RIPng functions, complete the following tasks:

  • Enabling IPv6 on the router

  • Configuring IPv6 addresses for interfaces to ensure that neighboring nodes are reachable at the network layer

Configuration Procedure

Creating RIPng processes is the prerequisite for enabling RIPng on interfaces.

Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 128529

Downloads: 274

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next