No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Delay for Transmitting LSAs on the Interface

Configuring the Delay for Transmitting LSAs on the Interface

Context

The LSA ages out in the LSDB of a local router instead of in the transmission process. You need to set the delay for an LSA before sending it. For a low-speed network, this configuration is necessary.

Do as follows on the router that runs OSPFv3.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ospfv3 trans-delay interval [ instance instance-id ]

    The delay in transmitting LSAs on the interface is set.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 131348

Downloads: 274

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next