No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling RIP on the Specified Network Segment

Enabling RIP on the Specified Network Segment

Context

After enabling RIP, you need to specify the network segment in which RIP runs. RIP runs only on the interfaces on the specified network segment. RIP does not receive, send, or forward routes on the interfaces that do not reside on the specified network segment.

Procedure

  • Enable RIP to send and receive routes on the specified network segment.
    1. Run the system-view command to enter the system view.
    2. Run the rip [ process-id ] command to enter the RIP view.
    3. (Optional) Run the undo verify-source command to disable source check for RIP packets.

      If the IP addresses on two ends of a P2P link belong to different network segments, the devices on the two ends cannot set up neighbor relationship unless source check is disabled.

    4. Run the network network-address command to enable RIP on the specified network segment.

      NOTE:
      • network-address specifies the address of a natural network segment.
      • An interface can be associated with only one RIP process.
      • If any network segment in which an interface configured with multiple sub-interface IP addresses resides is associated with a RIP process, the interface cannot be associated with any other RIP processes.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 130513

Downloads: 274

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next