No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview of RIP

Overview of RIP

Definition

Routing Information Protocol (RIP) is a simple Interior Gateway Protocol (IGP). RIP is a Distance-Vector protocol that uses hop count to measure the distance between the local device and the destination. RIP exchanges routing information using UDP packets on UDP port 520.

Two versions are available for RIP: RIP-1 and RIP-2. RIP-2 is an extension to RIP-1.

Purpose

RIP is easy to implement, and is easier to configure and manage than OSPF and IS-IS. Therefore, RIP is applicable to small-sized networks, such as campus networks and simple LANs. It is not suitable for complex environments or large-sized networks.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 144312

Downloads: 280

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next