No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Preference Value for IPv6 IS-IS

Configuring a Preference Value for IPv6 IS-IS


If multiple routes to the same destination are discovered by different routing protocols running on the same device, the route discovered by the protocol with the highest preference is selected.

To prefer a IPv6 route discovered by IS-IS, configure a higher preference value for IS-IS IPv6 route. In addition, a routing policy can be configured to increase the preferences of specified IS-IS IPv6 routes, without affecting route selection.


  1. Run system-view

    The system view is displayed.

  2. Run isis [ process-id ]

    The IS-IS view is displayed.

  3. Run ipv6 preference { route-policy route-policy-name | preference }*

    The IS-IS IPv6 route preference value is configured.

    The default IS-IS IPv6 route preference value is 15. A smaller preference value indicates a higher preference.

Updated: 2019-12-27

Document ID: EDOC1000174069

Views: 198013

Downloads: 354

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next