No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring OSPF GR

Configuring OSPF GR

Configuring OSPF GR to avoid traffic interruption and route flapping caused by the active/standby switchover.

Applicable Environment

To avoid traffic interruption and route flapping caused by the active/standby switchover, you can enable OSPF GR.

After the OSPF process is restarted through GR, the Restarter and the Helper reestablish the neighbor relationship, exchange routing information, synchronize the LSDB, and update the routing table and forwarding table. These operations ensure the fast convergence of OSPF and the stability of the network topology.

In practical application, in order to realize that business forwarding is not affected by motherboard failure, it is usually possible to configure BGP GR in the hardware environment of dual motherboard to make sense.

All the models support the GR Helper, and only AR3200 series support the GR Restarter.

Pre-configuration Tasks

Before configuring OSPF GR, complete the following tasks:

Updated: 2019-12-27

Document ID: EDOC1000174069

Views: 196519

Downloads: 324

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next