No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring OSPFv3 NSSAs

Configuring OSPFv3 NSSAs

Configuring a non-backbone area on the border of an autonomous system (AS) as a not-so-stubby area (NSSA) can reduce entries in the routing table and the amount of routing information to be transmitted. This section describes how to set the cost of the default route to an NSSA and adjust the selection of the default route.

Applicable Environment

An NSSA allows the transmission of Type 7 LSAs, which are generated by ASBRs in an NSSA. The Type 7 LSAs converting into Type 5 LSAs in the NSSA and advertised to other areas.

Pre-configuration Tasks

Before configuring an OSPFv3 NSSA, complete the following tasks:

Updated: 2019-12-27

Document ID: EDOC1000174069

Views: 187909

Downloads: 316

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next