No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
MENU
Support Documentation

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Link Cost for an OSPF Interface

Setting the Link Cost for an OSPF Interface

Context

OSPF can automatically calculate the link cost for an interface according to the interface bandwidth. You can also set the link cost for the interface using commands.

If you do not set the cost of an OSPF interface using the ospf cost cost command, OSPF automatically calculates the cost of the interface according to the interface bandwidth. The calculation formula is as follows: Cost of the interface = Bandwidth reference value/Interface bandwidth. The integer of the calculated result is the cost of the interface. If the calculated result is smaller than 1, the cost value is 1. Changing the bandwidth reference value can change the cost of an interface.

Procedure

  • Setting the link cost for an OSPF interface
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The OSPF interface view is displayed.

    3. Run ospf cost cost

      The cost of the OSPF interface is set.

  • Setting the bandwidth reference value
    1. Run system-view

      The system view is displayed.

    2. Run ospf [ process-id ]

      The OSPF process view is displayed.

    3. Run bandwidth-reference value

      The bandwidth reference value is set.

      The parameter value specifies the bandwidth reference value used to calculate the link cost, in Mbit/s.

      NOTE:

      Ensure that the bandwidth reference values of routers in an OSPF process are the same.

Translation
简体中文
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 122746

Downloads: 269

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next
Enterprise APP

Copyright © 2019 Huawei Technologies Co., Ltd. All rights reserved.