Rate and give feedback
:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling RIPng on Interfaces
Context
After RIPng is enabled on an interface, devices can exchange RIPng routing information through this interface.
Procedure
- Run system-view
The system view is displayed.
- Run interface interface-type interface-number
The interface view is displayed.
- Run ripng process-id enable
RIPng is enabled on the specified interface.
![]()
NOTE: If IPv6 is not enabled in the interface, this command cannot be run.
This command is not supported on ATM interfaces.
If RIPng needs to be enabled on multiple interfaces of a router, repeat steps 2 and 3.
Previous
